Magnetic bracelets are a common item in any shop and this tutorial demonstrates how to make magnets for your own magnetic bracelet.
You’ll need:A magnetic drill.
A magnetic needle.
The magnet is soldered onto the magnetic drill, which will also need a hole punch to drill a hole into the magnet.
Step one: Drill a hole in the magnetStep two: Cut the magnetic magnet into smaller piecesStep three: Drill the hole in each piece, making sure the hole punches are centered on the magnet pieceYou’ll also need:1) A drill bit.2) a needle.3) a magnet, soldered to the magnet in the drill.4) magnets for the magnets.
You can find the exact measurements of the magnet and the magnets at the magnets page.
Step four: Cut each piece in halfStep five: Drill each hole in one of the magnetsStep six: Drill into each of the other magnetsYou’ll probably need to drill the holes into the magnetic holes in both magnets.
This is not a huge deal, just make sure the holes are centered so the magnets will sit snugly together.
You don’t need to be a professional magnetist to do this, but you may need to use a smaller drill bit for this step.